Categories
BLOG

magnets for water pipes

Magnets for water pipes

The first time you shampoo your hair you’ll notice a large increase in shampoo suds. Your first thought will be that you used too much shampoo. The odds are, you used about the same amount you always do but the treated water created far more soap bubbles. The magnetic water conditioning will have you reducing the amount of soaps, laundry detergent, and shampoo for the first few weeks as you adjust to this improved condition.

Two Part System for
Cold & Hot Water

The residential water conditioning system comes with two sets of magnets, each set consisting of two magnets. Two magnets clamp together on opposing sides of the cold water pipe and the other two magnets clamp together on opposing sides of the hot water pipe. This permits the magnetic field to penetrate the pipe.

NOTE: The magnets may be installed on copper, pvc or plastic pipe.
Do not use on steel or galvanized pipe.

1. COLD WATER PIPE
I nstall one set on the cold water pipe (see Installation below), after the water meter and before the hot water tank. Be sure magnets are installed after any grounding wire that may be attached to the cold water inlet pipe of the main waterline.

2. HOT WATER PIPE
Install one set on the hot water pipe where it leaves the water heater.

Installation

1. Remove the paper backing from the adhesive strip on each magnet. This adhesive strip will help hold the magnet in place for step 2 & 3.

2. Place one magnet on the water pipe as shown in the diagram above, then place the second magnet of the set on the opposing side of the pipe.

3. Using one of the supplied cable ties, feed the cable tie through the slot of one magnet, around the pipe and through the slot on the second magnet, then feed the end into the cable tie lock.

3. Tighten the cable tie ensuring the magnets have stayed in place opposite each other on the pipe.

4. If you placed the first sets of magnets on the cold water pipe, then now do the hot water pipe, or vice versa.

5. That’s it, you’re done.

You are now ready to experience the free magnetic energy as it conditions your water .

DO YOU OWN A RV?

Water line magnets will make a world of difference in your recreational vehicle. Travelling around from place to place with no control over the water quality that enters your RV, you will immediately notice less spotting on your shower walls, dishes, cutlery and counter tops. Installation is the same as laid out above. Place one set of magnets where the water line enters your RV and one set where the water exits the hot water heater. It’s that simple.
NOTE: Because of the constant shifting of an RV as it rolls down the road, the magnets may shift position. After using the cable ties in the photos above, wrap the magnets with duct tape to keep them in place.

How to Clean Your
Hot Water Tank with
Magnetic Water Conditioners

After the magnetic conditioners have been in your home for 3 to 4 weeks it’s time to see what’s going on in the hot water tank. Take a short piece of garden hose around 4 feet in length and put it on the hose fitting at the bottom of your hot water tank. Place the end of the hose in a bucket and open the drain valve long enough to fill the bucket about halfway. In most cases you will be left with water that is either cloudy or has small pieces of calcium in it, or both.

Follow this easy step every 3 to 4 weeks until the water is clear and there are no pieces of calcium. At this point the lime scale build up has been removed from the inside of your hot water tank, and you no longer have to do this. This process can take up to a year or more depending on the amount of build up that there is in the hot water tank and the level of hardness in the water.

What You’ll Receive

Two sets of magnets with two cable ties per set.
One set for cold water pipe and one set for hot water pipe.

Compared to the cost and installation of a water softener, the cost to
replenish the salt and the time it takes to tote in those heavy bags
let alone remembering to add the salt, the magnetic water conditioning
may well be the best bargain of the year. AND, it is much better
for the environment.

Two sets of magnets, with cable ties, is $60.00USD*.
Shipping anywhere in North America is $20.00USD.
Shipments are Insured and Trackable.

Single sets of magnets are available for $30.00USD* a set, cash payment.
Shipping anywhere in North America is $20.00USD.
Shipments are Insured and Trackable.

Local pick up in Regina is available to save on shipping.

*Saskatchewan residents subject to 5% PST and 5% GST taxes.
*All other Canadian residents subject to 5% GST.
No taxes on orders shipped outside of Canada.

Pay via PayPal (which accepts credit cards) to: [email protected]

Testimonials ON MAGNETIC
WATER CONDITIONING

2. I installed the magnets and within three days we noticed a major difference in the taste of our water. Showering left a noticeable difference in our hair and skin. It truly is an excellent water conditioner. This product is well worth the minimal amount you pay for it.

4. My hands are very susceptible to dryness and cracking. If I wasn’t using a water softener I had to continually coat my hands with lotion. We do a lot of rving and I don’t have a water softener in our rv. Once my husband installed the magnets in our rv my hands were fine. I am very happy with these magnets. It’s made a huge difference. So much so we discontinued using our water softener at home and installed these magnets in the house too.

5. As a single father of two young girls I do a lot of laundry. From the time I put the magnets on my water line I noticed I use a lot less detergent. This has to be beneficial to my daughters’ skin. I no longer worry about getting all the detergent from their clothes as I hardly use any. Also, the clothes seem to come out brighter than before.

6. We had friends visit us on our acreage. They said “What did you do to your water?” I asked what she meant. She said on their previous visits there was always a smell to the water in the shower and now there is no smell. It took a second to realize we had installed the water line magnets a month earlier. We love them.

Magnets for water pipes The first time you shampoo your hair you’ll notice a large increase in shampoo suds. Your first thought will be that you used too much shampoo. The odds are, you used

Magnets for water pipes

For more than 35 years, magnetic treatment of water has been proven to reduce “hardness” caused primarily by calcium and magnesium. Water treatment can prevent deposits of these minerals on the inside of pipe walls, as well as descale the existing buildup of solids.

Typical applications of these magnets include ice machines, water coolers, instant water heaters, dishwashers, boats, air conditioners, restaurants, homes, solar panels, agricultural pipe, car wash facilities, spas, factories, hospitals, mines, boilers, steel fabricators, public pools, cooling towers, industrial drainage pipes, sewage treatment outlet pipes and many others!

Attach to intake water pipe and reduce “hardness” caused by calcium and magnesium.

Water treatment can prevent deposits of these minerals on the inside of pipe walls, as well as descale the existing buildup of solids.